warranties or instruction manuals for taps and showerheads, etc.įor any water fixtures produced from 2005 onwards, the easiest way to check if they meet the required efficiency standard is to look for products with a WELS rating of three stars or higher.Lessors/agents should be able to demonstrate the presence of water efficient devices where it may be unclear, such as by providing copies of: The presence of water efficient devices should be noted on the Entry condition report (Form 1a). How can the lessor/agent prove the premises are water efficient?Īt the start of the tenancy agreement, the lessor/agent and tenant should negotiate arrangements for water charging and frequency of charges. These taps are not required to be water efficient. The requirement does not apply to other taps in the premises such as bath tub taps, outside taps for the garden, or taps which supply washing machines or dishwashers. The requirement for taps applies only to internal cold water taps that are installed over a hand basin, kitchen sink or laundry trough (including single mixer taps). Internal cold water taps and single mixer taps (excluding bathtub taps and taps for appliances)Ī maximum flow rate of 9 litres per minuteĪ dual flush function not exceeding 6.5 litres on full flush and 3.5 litres on half flush and a maximum average flush volume of 4 litres (based on the average of 1 full flush and 4 half flushes) Minimum water efficient standard required *if the above criteria are met What are water efficient rental premises?Ī rental premises is considered water efficient if certain water fixtures meet the standards listed in the table below. The lessor must pay all fixed charges for water supply Sewerage is not a service charge as defined by the Act and cannot be passed onto the tenant (may appear on the bill as fixed or variable)
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |